![]() Other general tips from Apple to avoid damaging your MacBook include not wiping too aggressively, not holding the compressed air nozzle too close, and making sure you don't get any moisture into openings (like the charging port) when wiping it down. Just be sure you're not using anything with bleach in it, as this could damage and discolor the keycaps. If you have a particularly sticky key or a really grimy build-up that might need a bit more work, Apple also suggests use wiping the keyboard with 70% isopropyl alcohol or 75% ethyl alcohol, or even a disinfecting wipe. Rubberized silicone padding gives the Mac Studio a non-slip grip. Hassle-free cleaning and maintenance: easily detach the PVC Filter and run under water to clean out dust. Be careful which 'holes' you are cleaning. Protects the performance of the Mac Studio with a built-in PVC filter, preventing dust build-up. Trying to clean the actual speaker holes will likely result in damage to the speakers cones whether you use compressed air, a vacuum, or a pick. Out of the fan-assembly, and out of the grills that would to the outside. Then use a can of compressed air to blow away the biggest chunks of debris. Then hold on to the rotors so that they dont start spinning. That is unscrew typically 3 screws and disconnect the cables. Repeat this with the laptop turned onto its left side, then finally upside-down, so you're blasting the keys from every angle. Some of the 'holes' may not actually be holes and may only be there for looks since having multiple small areas with holes would not look nice. Open up the bottom case, disassemble the fans. Once you've done this you can then rotate your MacBook to its right side and spray the keyboard again from left to right. You wont get all the dust out of the laptop, but at least it will stop plugging up the vents, fans, and whatever else its stuck to. With any luck, the jets of air will knock some of the dust loose and it will escape the laptops vents. You're going to want to use the compressed air in steady left-to-right 'zig-zag' motions, doing one half of the keyboard at a time. Get a can of compressed air, point it at the laptops cooling vents, and give them a few short bursts of air. Once you've got everything angled up, let it rip!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |